Dahua VTO4202F Series User Manual

Configuration 21
Add VTO Figure 4-10
Configure the parameters, and be sure to add the SIP server itself too. See Table 4-2. Step 3
Table 4-2 VTO configuration
Parameter
Description
Rec No.
The VTO number you configured for the target VTO. See the details
in "4.2.2 Configuring VTO Number."
Register Password
Keep default value.
Build No.
Available only when other servers work as SIP server.
Unit No.
IP Address
The IP address of the target VTO.
Username
The user name and password for the web interface of the target
VTO.
Password
Click Save. Step 4
4.2.6 Adding Room Number
You can add the planned room number to the SIP server, and then configure the room number
on VTH devices to connect them to the network. This section applies to the condition in which a
VTO device works as SIP server, and if you use other servers as SIP server, see the
corresponding manual for the detailed configuration.
The room number contains at most 6 numbers or letters or their combinations, and it cannot be
the same as any VTO number.
Log in to the web interface of the SIP server, and then select Household Setting > Step 1
Room No. Management.
The Room No. Management interface is displayed. See Figure 4-11.

Dahua VTO4202F Series Specifications

General

Brand	Dahua
Model	VTO4202F Series
Category	Security Camera
Language	English