Danfoss air User Manual

Instructions Menu
The Service menu is activated by pressing the Air
Dial button for 5 seconds.
In the Service menu the installer can set
individual functions to which it is not desirable
that the end user has access.
If the installer is dealing with a system where for
some reason there is a need to reset the system,
it should be done as follows:
1. If the system has already been balanced, the
basic steps used must be noted on a piece of
paper for later use. This is done by going into
the following menu item and reading the fan
steps for both the supply and exhaust fans:
Service > Info > basic steps
2. Remove the batteries from the Air Dial and
insert them again. While the last battery is
inserted, hold down the button - continue to
hold down the button until you hear a beep
from the Air Dial. The Air Dial is now ready in
start-up mode.
3. Remove the supply or communication cable
connecting the unit to the communication
module - hold down the button on the
communication module while you reconnect
the cable. Continue to hold down the button
on the communication module for 5 seconds
until only the green LED is flashing.
4. The system has now been reset to its factory
settings and can be registered as described in
Chapter 3.
If you noted the system’s basic steps in Point 1
above, these are the values that you should use
when the Air Dial asks for the required basic step
during the registration procedure.
Service
Back
Info  
As normal, but fan steps are displayed without being rounded off
Set filter timer  
Set filter period
Set language  
Select required language on Air Dial
Set basic step  
Set-up mode, installer controls both fans 0-100%
Link test  
Used to test the wireless connection
4.1 Service menu
4.2 System reset
15
VIEWA402

Danfoss air Specifications

General

Brand	Danfoss
Model	air
Category	Air Conditioner
Language	English