Instruction APP pump instruction APP 0.6-1.0, APP 1.5-2.5 and APP 3.0-3.5
8
180R9065 / 521B0733 / DKCFN.PI.013.C4.2T / 09.2012
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice.
This also applies to products already on order provided that such alterations can be made without subsequential changes being necessary in specications already agreed.
All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
Danfoss A/S
High Pressure Pumps
DK-6430 Nordborg
Denmark
6.1 Periodic maintenance
The APP pump is designed so that lubrication
follows from the water itself and there is thus no
oil in the pump.
The pump requires no periodic replacements of
seals and valve parts.
6.2 Repair
In case of irregular function in the pump, please
contact the Danfoss Sales Organisation.
6. Service
5.5.2 Open-ended systems with direct water
supply
1. Disconnect the water supply to the pump.
2. Through the lower bleeding plug, empty
the pump housing of water and close it
again.
3. Connect the pump to a tank of e.g. 25 litre
6 gal. of anti-freeze additive. Connect a
hose to the inlet port of the pump and via
another hose return the ow from the
outlet port to the tank with anti-freeze
additives.
4. Quickly start and stop the pump. Make sure
that the pump does not run dry. The pump
is now protected against internal corrosion
and frost.
To Next Page
Loading...
Need help?
General
