Service Settings
EY.65.H4.02
73
10.4.10 Energy Consumption
Sensor input When energy consumption is being measured by a sensor connected to one of the sen-
sor inputs S8, S9, S10 or S11), the following picture displays the energy consumption
and allows you to reset the measurement:
Display text Parameter Default value,
range
Description
Accum.
Accumulated Range:
0-9999 MWh
or
0-9999 GWh
The accumulated energy consumption
Energy
Range:
0-999 kW or
0-999 MW
The currently measured energy con-
sumption. This parameter is read-only
and cannot be modified
Reset
Select this parameter and press
to
reset the accumulated energy consump-
tion to 0. A new calculation of the accu-
mulated value is started
LON input When energy consumption is being measured by a device connected to the ECL 2000
via LON, the following picture displays the measured energy consumption:
Display text Parameter Default value,
range
Description
Accum.
Accumulated Range:
0-9999 MWh
or
0-9999 GWh
Read-only parameter. The accumulated
energy consumption
Energy
Range:
0-999 kW or
0-999 MW
Read-only parameter. The currently
measured energy consumption
Note:
When energy consumption is being measured by a device connected via LON, the ac-
cumulated consumption cannot be reset. This is due to the fact that the accumulated
energy consumption is calculated by the device and transmitted to the ECL 2000.
To Next Page
Need help?
General
