Figure 6. EC-C1200
Figure 7. Schematic of the inverter powerstage
The main machine power driving parameters are shown in the machine rating plate. For
more
information, please contact Danfoss
representative.
You can connect one of the temperature signals (from the low voltage connector) to the
temperature surveillance pin in the inverter
and make sure that the inverter has the machine
temperature protection feature activated.
Mounting structure
Supporting structure requirements
Do not install the electric machine near or in direct contact with easily ammable materials
.
The surface of the electric
machine can be hot.
The mating housing arrangement of the electric machine must be secure and sufficiently rigid to
prevent vibrations and mechanical failures. Necessary actions should be taken to avoid corrosion
on the mating housing arrangement.
To Next Page
Loading...
Need help?
General
