FC 300 Instruction Manual
How to Install
" About H ow to Install
This chapter covers mechanical and e lectrical installations to and from power
terminals and control card terminals.
Electrical installation of options is described
in the corresponding "Option Guide".
" How to Get Started
You can carry out a quick and EMC-correct
installation of the FC 300 by following the
steps described below.
Read the safety instructions before
installing the unit.
Diagram showing basic installation including,
electrical connection, motor, start/stop key, and
potentiometer for speed adjustment.
11
MG.33.A4.22 - VLT is a registered Danfoss trademark
To Next Page
Loading...
Need help?
General
