FC 300 Instruction Manual
How to Program
Data storage in LCP:
1. Go to par. 0-50 LCP copy
2. Press the [OK] key
3. Select "All to LCP"
4. Press the [OK] key
All parameter settings are now stored in the LCP indicated by the progress ba r.
When 100% is reached, press [OK].
NOTE
Stop the unit before performing this operation.
You can now connect the LCP to another adjustable frequency drive and copy the parameter
settings to this adjustable frequency drive as well.
Data transfer from L CP to drive:
1. Go to par. 0-50 LCP copy
2. Press the [OK] key
3. Select "All from LCP"
4. Press the [OK] key
The parameter settings stored in the LCP are now transferred to the drive indicated by
the progress bar. When 10 0% is reached , press [OK].
NOTE
Stop the unit before performing this operation.
" Reset to Default Setting
To restore all parameter values to their default setting, go to par. 14-22 Operating Mode and
select Initialization. Power down the ad justable frequen
cy drive. The a djustable frequency drive
will automatically restore to default settings during the next power-up.
" Adjust Display Contrast
Hold down [STAT U S] and use the up or down navigation arrow to adjust the displ ay contrast
39
MG.33.A4.22 - VLT is a registered Danfoss trademark
To Next Page
Loading...
Need help?
General
