FC 300 Instruction Manual
How to Install
" Encoder Option MCB 102
The encoder module is used for interfacing feedback from motor or process. Parameter settings in group 17-xx
Used for:
• VVC plus closed-loop
• Flux Vecto r S peed control
• Flux Vector Torque control
• Permanent magnet motor with SinCos
feedback (Hiperface
®
)
Incremental encoder: 5 V TTL type
SinCos Encoder: Stegmann/SICK
(Hiperface
®
)
Selection of parameters in par. 17-1* and
par. 1-02
When the encoder option kit is ordered
separately, the kit includes:
• Encoder module M CB 102
• Enlarged LCP fixture and enlarged
terminal cover
The encoder option does not support
FC 302 adjustable frequency drives
manufactured before week 50/2004.
Min. software version: 2.03 (par. 15-43)
Installation of M CB 102:
• Thepowertotheadjustablefrequencydrivemustbediscon
nected.
• Remove the LCP, the terminal cover, and the cradle from the FC 30x.
• Fit the MCB 102 option in slot B.
• Connect the control ca ble s and fasten the cables by the clamp
to chassis.
• Fit the enlarged LCP fixture and enlarged terminal cover.
• Replace the LCP.
• Connect the powe r to the adjusta ble frequency drive.
• Select the encoder functions in par. 17-*.
• See also descrip tion in chapter Introduction to FC 300,sectionSpeed PID Control
27
MG.33.A4.22 - VLT is a registered Danfoss trademark
To Next Page
Loading...
Need help?
General
