Danfoss FP715 Si User Manual

5
Not Used
Gravity
5/2 Day
7 Day
Sw.1
Sw.2
Sw.3
Sw.4
Not Used
Pumped
7 Day or 24 Hour
24 Hour
DIL switch settings and Advanced Programming Options
Tick the INSTALLER SETTING box
on the inside fl ap label to notify
user in which mode their unit is
set (24hr, 5/2 day or 7 day).
DIL Switch Settings
Before mounting the unit, ensure the
4 DIL switches on the rear have been
moved to the required settings.
!
INSTALLER SETTING
24 Hour
5+2 Day
7 Day
Advanced Programming Options
To enter advanced programming press PROG, + and DAY/HOL
together and hold for 5 seconds.
Option 1 - (3 or 2 On/Off ’s per day)
Use + or - to change between 3 or 2 on/off ’s each day.
Option 2 - (Disable or enable auto time change)
Press NEXT, then use + or - to change between auto time
change enabled to auto time change disabled.
Option 8 - (Advanced Copy Functions)
Press NEXT, then + or - to change between the following copy
options:
(0) Standard copy in 7 day and 5+2 day.
(1) Enhanced copy in 7 day and 5+2 day
(2) Enhanced copy in 7 day and AB copy in 5+2 day.
For an explanation of the copy features and how to use them
please see page 6.
Press PROG to return to RUN.
3
2
3 on/off ’s each day (Factory setting) 2 on/off ’s each day
Auto time change enabled (Factory setting) Auto time change disabled

Danfoss FP715 Si Specifications

General

Brand	Danfoss
Model	FP715 Si
Category	Temperature Controller
Language	English