7
Service Interval Timer
The FP715 Si is fi tted with an installer setback service interval
timer. If this feature is required please contact our technical
department. Setting instructions for this gas safety feature are
only available to bona fi de heating installers.
To use the AB copy function – press the PROG button:
This will show the “A” days, with all the days selected. 1.
Use the 2. DAY button to highlight a day.
Subsequent presses of the 3. DAY button will increment
through the days.
Press the 4. + button to select a specifi c day as an “A” day, or
press the – button to specify a day as a “B” day.
Once the day has been selected as an “A” or “B” day the 5.
programme will automatically jump to the next day.
When the last day of the week is active, pressing 6. +, -, or DAY
will move back to the “A” days displayed with no selected
(fl ashing) days (see image below).
Repeat 2 to 6 until all selections have been made. 7.
When selections are completed, press the 8. PROG button to
move to event programming.
Event Programming in AB mode
Programme “A” day events using the 1. + (time advance), - (time
decrease), and NEXT (next period) buttons.
Press the 2. DAY button to change to programme the “B” days
Programme “B” day events using the 3. + (time advance), - (time
decrease), and NEXT (next period) buttons.
A Days B Days
Mon Tues Thurs Fri Sat Wed Sun
DIL switch settings and Advanced Programming Options
To Next Page
Loading...
Need help?
General
