Danfoss OPTYMA Control AK-RC 101 User Manual

4 RS8FD402 © Danfoss A/S 2014/11 OPTYMA
TM
Control single-phase AK-RC 101
The unit described in this manual has an ID label on
the side showing all the relevant identication data:
• Name of Manufacturer
• Type and code number
• Product name
• Power supply
• Serial number (10 digits)
• Date (Day/Month/Year)
Identication data
1. Install the device in places where the protection
rating is observed and try not to damage the
housing when drilling holes for wire penetrations
2. Do not use multi-polar cables which have
wires connected to inductive/power loads and
signalling wires (e.g. sensors and digital inputs).
3. Do not t power supply wiring and signal wiring
(sensors and digital inputs) in the same
raceways or ducts.
4. Minimise the length of connector wires so that
wiring does not twist into a spiral shape as this
could have a detrimental eect on the electronics.
Installation
5. Fit a general protection fuse before the electronic
controller.
6. All wiring must be of a diameter suitable for
relevant power levels.
7. If a sensor extension is required, the wires
must have a diameter of at least 1 mm
2
.
8. If data communication is used, it is important
that the data communication cable is correctly
installed. See separate literature, no. RC8AC...
9. If data communication is used, the alarm relay
cannot be used.
Important information for the installer.
Installation to be done by authorised person only!
For the purposes of assembly and use, the electronic
OPTYMA
TM
Control single-phase unit comes with:
• Three rubber washers, to be tted between the
xing screws and the housing back panel
• One user’s manual.
• Two temperature sensors
Standard assembly kit

Danfoss OPTYMA Control AK-RC 101 Specifications

General

Brand	Danfoss
Model	OPTYMA Control AK-RC 101
Category	Control Panel
Language	English