Danfoss TS715 Si User Manual

16
!
Before you change the preset programmes
Your installer will have set your unit to operate in one of the
following modes:
 5/2 day - one set of programmes for weekdays and another
for weekends (page 17-18)
 7 day - di erent settings for each day of the week
(page 19-20)
 24 hour - one set of programmes for the whole week
(page 21)
See INSTALLER SETTING tick box on inside  ap label to
ascertain which mode your unit is set .
Changing Preset Programmes
Please Note
The unit must be programmed in sequence and ON/OFF
times cannot be set out of sequence.
If you want to leave a preset time as it is, simply press NEXT
to move on to the next setting.
Your installer will have set your unit to programme either
2 or 3 ON/OFFs per day. If your clock has been installed to
allow 3 ON/OFFs and you do not wish to use one of the
ON/OFF settings, simply programme the ON time to be the
same as the OFF time and the setting will not operate.

Danfoss TS715 Si Specifications

General

Brand	Danfoss
Model	TS715 Si
Category	Timer
Language	English