64 MG.30.A7.02 - VLT
®
is a registered Danfoss trademark
“LOCK” switch
There is a way to avoid unwanted pro-
gramming. It is done by opening the
switch pin 01 on the control card.
Time out
Local reference (parameter 004) is not left
automatically after 20 seconds.
The display is a three-line LCD display.
Line A is used to display operator read-
outs. It will show the value corresponding
to the setting in DISPLAY MODE.
The selected value will remain in the
display line during programming of para-
meters.
Line B displays information on parameters,
direction, and re-set status.
Line C displays information on status and
setup or data value.
The software automatically leaves DATA
MODE after 20 seconds if no operation is
recorded.
By pressing
Data
once, it is possible to
return to DATA MODE and program the
parameter which was left after 20 sec.
Display layout
Avoid unwanted data change
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
