65MG.30.A7.02 - VLT
®
is a registered Danfoss trademark
Please note: You have to press
Stop
Reset
to stop
the motor before changing the data values
of some parameters (see factory settings).
Menu build-up
The frequency converter has a menu sys-
tem with several parameters to be used to
optimise your motor operation.
The parameters are divided into 7 groups
(group 0 - group 6).
There are also groups for different options.
They are described in guidelines for each
option.
Parameter grouping
0.. Operation and display 000-099
1.. Load and motor 100-199
2.. References and limits 200-299
3.. Functions and timers 300-399
4.. Inputs and outputs 400-499
5.. Serial data interface 500-599
6.. Service and diagnosis 600-699
The parameter number is made up of three
digits.
The digit on the left indicates the group.
Parameter
numbering
Travelling through
the menu
After the first power-up you will find the
frequency converter in DISPLAY MODE.
Changing group
If you want to travel through the menu, use
the key
Menu
followed by the keys
+
or
–
(see page 61).
Changing a parameter number
You can enter the parameters of the
selected group with the key
followed
by
+
or
–
.
+
increases and
–
decreases the
parameter number.
Menu build-up
When you have chosen a parameter and
want to change its data value, press the
Data
key followed by the
+
or
–
key.
The data value can be a digit or a text.
Data value of a
parameter
Changing a data value:
digit
When you have pressed
Data
the digit to the
right will be active and be shown flashing.
The other digits can be activated one by
one by pressing
Data
one, two or three times.
The activated digit can be changed by
pressing
+
or
–
.
Changing a data value:
text
If the data value of the chosen parameter
is a text, the display shows the selected
text.This can be changed by pressing
Data
and then
+
or
–
. All options are then
shown one by one. The text shown in the
display will be stored at the same moment
you leave DATA MODE.
You are storing the data value by pressing
Menu
. Now you have activated the para-
meter number and can travel through the
group of parameters again using
and
–
.
Leaving DATA mode
Within each group the parameters are
numbered, starting with 0.
For example, in group 1..: 100, 101, 102....
A new data value is stored on leaving
DATA MODE, or automatically after 20
seconds.
Please note: You have to press
to stop
the motor before changing the data values
of some parameters (see factory settings).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
