To Next PageTo Next PageTo Previous PageTo Previous Page
What to do if Danfoss VLT FC 102 N500 trip lock?
If a Danfoss DC drive experiences a trip lock, it means an alarm occurred, and the motor has stopped. To resolve this, first, identify and clear the cause of the alarm. Then, reset the drive by: pressing the [Reset] button, using remote control terminals, or via serial communication.
General| Power Range | 0.75 kW to 500 kW |
|---|---|
| Input Voltage | 380-480 V |
| Output Voltage | 0 V to Input Voltage |
| Communication Protocols | CANopen |
| Cooling | Forced air cooling |
| Enclosure Type | IP20, IP21 |
| Protection Features | Overcurrent, overvoltage, undervoltage, short circuit, overtemperature |
Specifies the requirements for personnel authorized to install, operate, and maintain the equipment.
Highlights critical warnings about preventing injury and equipment damage.
Outlines general requirements for safe and proper drive installation.
Covers procedures for installing the drive into its final location, including cable entry and securing.
Highlights general safety warnings and specific electrical installation hazards.
Provides guidelines for achieving electromagnetic compatibility during installation.
Presents a basic wiring diagram for D9h and D10h enclosed drive configurations.
Presents a basic wiring diagram for E5h and E6h enclosed drive configurations.
Covers wiring procedures within the control compartment, including safety and component details.
Provides essential procedures for connecting motor, mains, and ground cables.
Covers recommendations and ratings for upstream fuse protection.
Refers to separate documentation for detailed Safe Torque Off (STO) wiring instructions.
Provides a comprehensive checklist of items to verify before initial drive startup.
Outlines procedures and safety warnings before applying power to the drive.
Details how to program the drive using the LCP and parameters.
Covers essential tests like motor rotation and encoder feedback before operation.
Recommends the procedure for initial drive startup after setup completion.
Discusses parameter storage, backup, and management for drive configuration.
Introduces common wiring configurations for various applications like AMA, speed, and feedback.
Shows wiring for Automatic Motor Adaptation (AMA) with T27 connected.
Shows wiring for Automatic Motor Adaptation (AMA) without T27.
Details wiring for analog speed reference using voltage or current inputs.
Describes wiring for analog feedback transducers using 2, 3, or 4-wire connections.
Introduces the system for warnings and alarms indicating faults and their causes.
Provides a guide to diagnosing and resolving common drive symptoms and issues.
