VLT
®
FCD Series
678 Configure Control Card
(CONFIG CONTROL CARD)
Value:
Standard version (STANDARD VERSION)
[1]
Profibus 3 Mbaud Version
(PROFIBUS 3 MB VER.)
[2]
Profibus 12 Mbaud Version
(PROFIBUS 12 MB VER.)
[3]
Function:
This parameter enables a configuration of a Profibus
Control Card. The default value depends on the
produced unit, also being the maximum obtainable
value. This means, that a control card only can be
down graded to a lower performance version.
✭ = factory setting. () = display text [] = value for use in communication via serial communication port
MG.04.B7.02 - VLT is a registered Danfoss trademark
100
To Next Page
Loading...
Need help?
General