Danfoss VLT FCM 315 User Manual

VLT
®
FCM Series
■ List of parameters
Functions to programme, to control, and to monitor via bus (PROFIBUS) or by PC.
Parame-
ter No. Function
Range/number of
settings/value Factory setting
Data
type
Conv.
index
001 Language 6 English 5 0
002 Local/remote control 2 Remote control 5 0
003 Local reference 000.000 4 -3
004 Active Setup 4 Setup 1 5 0
005 Programming Setup 4 Active setup 5 0
006 Copying of Setups 4 No copying 5 0
007 LCP copy 4 No copying 5 0
008 Display scaling of motor frequency 100 6 -2
009 Display line 2 24 Frequency [Hz] 5 0
010 Display line 1.1 24 Reference [%] 5 0
011 Display line 1.2 24 Motor current [A] 5 0
012 Display line 1.3 24 Power [kW] 5 0
013 Local control/configuration 5 LCP digital control/par. 100 5 0
014 Local stop 2 Possible 5 0
015 Local jog 2 Not possible 5 0
016 Local reversing 2 Not possible 5 0
017 Local reset of trip 2 Possible 5 0
018 Lock for data change 2 Not locked 5 0
019 Operating state at power up, local c. 3 Forced stop, use saved ref. 5 0
100 Configuration 2 Speed, open loop mode 5 0
101 Torque characteristics 4 Constant torque 5 0
102 Motor power XX.XX kW - dep. on unit 6 1
103 Motor voltage XX.XX V - dep. on unit 6 0
104 Motor frequency XX.X Hz - dep. on unit 6 -1
105 Motor current XX.XX A - dep. on unit 7 -2
106 Rated motor speed XX rpm - dep. on unit 6 0
117 Resonance damping off - 100% off % 6 0
126 DC braking time 0.0 (off) - 60.0 sec. 10.0 sec. 6 -1
127 DC brake cut-in frequency 0.0 Hz - f
MAX
0.0 Hz 6 -1
128 Motor thermal protection 2 Disable 5 0
132 DC braking voltage 0 - 100 % 0 % 5 0
133 Start voltage 0.00 - 100.00 V Motor dependent 6 -2
134 Start compensation 0.0 - 300.0 % 100.0 % 6 -1
135 U/f ratio 0.00 - 20.00 V/Hz Motor dependent 6 -2
136 Slip compensation -500.0 - +500.0 % 100.0 % 3 -1
137 DC holding voltage 0 - 100 % 0 % 5 0
138 Brake cut out frequency 0.5 - 132 Hz 3.0 Hz 6 -1
139 Brake cut in frequency 0.5 - 132 Hz 3.0 Hz 6 -1
Conversion index:
This number refers to a conversion figure to be used
when writing or reading via serial communication
with a frequency converter.
See Databytes in Serial Bus.
D
ata type:
Data type shows the type and length of the telegram.
Data type Description
3Integer16
4Integer32
5Unsigned8
6Unsigned16
7Unsigned32
9Textstring
MG.03.H3.02 - VLT is a registered Danfoss trademark
98

Danfoss VLT FCM 315 Specifications

General

Brand	Danfoss
Model	VLT FCM 315
Category	DC Drives
Language	English