Danfoss VLT HVAC Series User Manual

9-94 Changed parameters (5)
Array [116]
No LCP Address
Read only
Range: Function:
0 N/A* [0 - 9999 N/A] This parameter displays a list of all the adjustable frequency drive parameters deviating from default
setting.
3.11 Main Menu - CAN Ser. Com. Bus - Group 10
3.11.1 10-** DeviceNet and CAN serial communication bus
Parameter group for DeviceNet CAN serial communication bus parameters.
3.11.2 10-0* Common Settings
Parameter group for configuring common settings for CAN serial communication bus options.
10-00 CAN Protocol
Option: Function:
[1] * DeviceNet View the active CAN protocol.
NOTE!
The options depend on installed option
10-01 Baud Rate Select
Option: Function:
Select the serial communication bus transmission speed. The selection must correspond to the
transmission speed of the master and the other serial communication bus nodes.
[16] 10 Kbps
[17] 20 Kbps
[18] 50 Kbps
[19] 100 Kbps
[20] * 125 Kbps
[21] 250 Kbps
[22] 500 Kbps
[23] 800 Kbps
[24] 1000 Kbps
10-02 MAC ID
Range: Function:
63. N/A* [0 - 63. N/A] Selection of station address. Every station connected to the same DeviceNet network must have an
unambiguous address.
3 Parameter Description VLT
®
HVAC Drive Programming Guide
3-110 MG.11.C6.22 - VLT
®
is a registered Danfoss trademark
3

Danfoss VLT HVAC Series Specifications

General

Brand	Danfoss
Model	VLT HVAC Series
Category	DC Drives
Language	English