Danfoss VLT Micro Drive User Manual

•
Protect users against supply voltage.
•
Protect the motor against overloading according
to national and local regulations.
•
The ground leakage current exceeds 3.5 mA.
•
The [Off/Reset] key is not a safety switch. It does
not disconnect the adjustable frequency drive
from line power.
1.2 Introduction
1.2.1 Available Literature
NOTE!
This Quick Guide contains the basic information necessary
for installing and running the adjustable frequency drive.
If more information is needed, the literature below can be
downloaded from:
http: //www.danfoss.com/BusinessAreas/DrivesSolutions/
Documentations
Title Literature
no.
VLT Micro Drive FC 51 Design Guide MG02K
VLT Micro Drive FC 51 Quick Guide MG02B
VLT Micro Drive FC 51 Programming Guide MG02C
FC 51 LCP Mounting Instruction MI02A
FC 51 De-coupling Plate Mounting Instruction MI02B
FC 51 Remote Mounting Kit Mounting Instruction MI02C
FC 51 DIN Rail Kit Mounting Instruction MI02D
FC 51 IP21 Kit Mounting Instruction MI02E
FC 51 Nema1 Kit Mounting Instruction MI02F
Line Filter MCC 107 Installation Instruction MI02U
Table 1.1
1.2.2
Approvals
Table 1.2
1.2.3
IT Line Power
NOTE!
IT Line Power
Installation on an isolated line power source, i.e., IT line
power.
Max. supply voltage allowed when connected to line
power: 440 V.
As an option, Danfoss offers recommended line filters for
improved harmonics performance.
Quick Guide
VLT
®
Micro Drive Quick Guide
1-2 MG02B722 - VLT
®
is a registered Danfoss trademark
11

Danfoss VLT Micro Drive Specifications

General

Brand	Danfoss
Model	VLT Micro Drive
Category	DC Drives
Language	English