Danfoss WP75- RF User Manual

12
Setting the Time/Day & Running the programme
Setting the Time & Day
Press PROG until the time and day number
begin to blink in the display.
DAY - Press DAY until correct day is shown
(1=Monday, 2=Tuesday etc).
TIME - Press + and - to change time (press
and hold to change in 10 min increments).
Press PROG again to accept the settings.
If you are happy to use the preset
programmes on page 11, you don’t need to
do anything else.
Press PROG until colon  ashes in display.
Your unit is in RUN mode and your hot
water will be heated according to the preset
programmes.
Running your programme
To
change
DAY
To change TIME

Danfoss WP75- RF Specifications

General

Brand	Danfoss
Model	WP75- RF
Category	Controller
Language	English