DataCard CD800 Installation And Administrator's Guide

72 Printer Manager
 Hopper1ImpressTemperature—Set the temperature of the impresser punch (in degrees
Celsius).
 Increase the value to increase the temperature of the impresser punch.
 Decrease the value to decrease the temperature of the impresser punch.
 Hopper1NumberOfImpresses—Enter the number of impressions to be stamped on the card.
The impresser can stamp up to three impressions in a row on the left, center, or right part of
the card.
 ImpresserSpeed—Set the speed of the impresser motor. The value is in increments of the
motor.
 Increase the value to increase the speed of the impresser motor.
 Decrease the value to decrease the speed of the impresser motor.
 L1CoolingTime—Specify the time, in milliseconds, to wait for the card to cool after applying
the overlay in the L1 laminator. The default is 0 (no delay).
 L2CoolingTime—Specify the time, in milliseconds, to wait for the card to cool after applying
the overlay in the L2 laminator before proceeding to the L1 laminator. The default is 1000 ms
(1 second). Enter 0 to turn off the delay.
 RollerTypeInstalledL1—Specify the type of roller installed in the L1 laminator. The options
are Standard, Rubber, or Custom.
 RollerTypeInstalledL2—Specify the type of roller installed in the L2 laminator. The options
are Standard, Rubber, or Custom.
 ScanBarCodeRetries—Specify the number of times the bar code scanner should attempt to
read a bar code on a serialized overlay. If the read fails, the next read attempt advances the
overlay to the next usable bar code on the overlay. This applies only to laminators that have
the optional bar code scanner installed.

DataCard CD800 Specifications

General

Brand	DataCard
Model	CD800
Category	Printer
Language	English