6. FUNCTION AND PROGRAMMING SELECTION
The functions implemented in the AREAscan
TM
DS2 light grids can be selected via remote.
The default configurations are given below:
Default configuration for emitter unit
The device is supplied with the maximum emission adjustment setting
(minimum sensitivity)
Sensitivity adjustment
Sensitivity adjustment is made using the trimmer located inside the
emitter unit lid. This function allows the operator to change the emitter
intensity.
With regard to the programmation and the selectable functions, refer to following paragraphs.
6.1. Remote programming
The function programming and selection is made using an user interface on a remote host, which
communicates with DS2 using the standard RS232 serial interface.
The interface can be found in the CD supplied with the device packet.
N.B.: DS2 device fix in memory the last setting configuration from remote user interface. At the
first interface startup, DS2 set it self following the factory configuration which is
eventually restoring by appropriate push-button “RESTORE”.
Fig. 7
To Next Page
Loading...
Need help?
General
