6PowerScan
®
7000 2D
2. The imager beeps.
3. Verify imager operation by scanning the part number bar code
from the back cover of this manual.
For additional USB programming and technical information, visit the
website listed on the back cover of this manual.
IBM SurePos
Scan one of the following “Plug and Play” codes to program the imager
for IBM SurePos (USB Hand Held imager) or IBM SurePos (USB
Tabletop imager).
NOTE
The following USB “Plug and Play” codes are
supported on specific models. Refer to the
Product Reference Guide to determine if this
interface applies to your unit.
NOTE
After scanning one of these codes, you must
power cycle the cash register
IBM SurePos
(USB Hand Held imager) Interface
IBM SurePos
(USB Tabletop imager) Interface
To Next Page
Loading...
Need help?
General
