Resetting the Standard Product Defaults
Quick Reference Guide 11
Resetting the Standard Product
Defaults
If programming settings for your scanner are in an unknown condition,
factory settings can be restored by scanning the “Standard Product
Default Settings” bar code below. A listing of factory default settings is
available in the PRG. Settings can vary, depending upon the interface
type.
Repairs
Repairs and/or upgrades are not to be performed on this product. These
services are to be performed only by an authorized service center. See the
Product Reference Guide for further information.
Maintenance
The imager provides reliable and efficient operation with a minimum of
care. Although specific maintenance is not required, the following peri-
odic checks ensure dependable imager operation:
Cleaning the Imager’s Window
Reading performance may degrade if the imager’s window is not clean.
If the window is visibly dirty, or if the imager isn’t operating well, clean
the window with a soft cloth or lens tissue dampened with water (or a
mild detergent- water solution). If a detergent solution is used, rinse
with a clean lens tissue dampened with water only.
Standard Product Default Settings
To Next Page
Loading...
Need help?
General
