Datamax Apex 3 User Manual

6
1.4 Attaching Belt Loop System
The belt loop system consists of two parts:
 A knob located on the back part of the printer just above the battery door
 A strap with a click-on connector
To attach the strap to the knob, insert the knob located at the bottom of the printer into the slot
of the connector. Pull down until a click is heard. The printer is now secure. The loop is then
placed over your belt to allow the printer to hang from either the left or right hip.
 To release the printer, press inward on the two connector latches and pull the knob clear
of the slot.
Note: Do not force or pull the printer from the connector without pressing inward
on the two latches.
FIGURE 5: KNOB CONNECTION AND QUICK CLIP

Datamax Apex 3 Specifications

General

Brand	Datamax
Model	Apex 3
Category	Printer
Language	English