DEEP SEA ELECTRONICS DSECONTROL DSE7000 Series User Manual

DSE Model 7000 Series Control and Instrumentation System Operators Manual
66 Part No. 057-074 7000 Series OPERATING MANUAL ISSUE 2 02/05/2008 ADM
9.2 ACCESSING THE ‘RUNNING’ CONFIGURATION EDITOR
The ‘running’ editor can be entered while the engine is running. All protections remain active if the engine is running
while the running editor is entered.
Press and hold the button to enter the running editor.
9.2.1 EDITING A PARAMETER
Enter the editor as described above.
Press the (left) or (right) buttons to cycle to the section you wish to
view/change.
Press the (up) or (down) buttons to select the parameter you wish to
view/change within the currently selected section.
To edit the parameter, press to enter edit mode. The parameter begins to flash to
indicate that you are editing the value.
Press the (up) or (down) buttons to change the parameter to the
required value.
Press to save the value. The parameter ceases flashing to indicate that it has
been saved.
To exit the editor at any time, press and hold the button.
9.2.2 ADJUSTABLE PARAMETERS (RUNNING EDITOR)
Running Editor (Factory default settings are shown in bold italicised text)
Section Parameter as shown on display Factory Setting
DISPLAY Contrast 50%
Language English

DEEP SEA ELECTRONICS DSECONTROL DSE7000 Series Specifications

General

Brand	DEEP SEA ELECTRONICS
Model	DSECONTROL DSE7000 Series
Category	Control Unit
Language	English