Dell 7330 User Manual

Printer Settings
Dell 7330 Mono Laser Printer
5-2
Printer Settings
This topic includes:
■ Accessing Power Saver on page 5-2
■ Selecting Output Options on page 5-3
■ Accessing the Startup Page on page 5-4
■ Accessing Load Paper Timeout on page 5-5
■ Selecting Tray Settings on page 5-6
■ Changing Printer Language on page 5-8
Accessing Power Saver
To save energy, the printer enters a Power Saver, low-energy consumption mode after a
pre-defined period of time since its last activity. In this mode, most printer electrical systems
are shut down. When a print job is sent to the printer, the printer enters Warmup Mode. You
can also warm up the printer by pressing the OK button on the control panel.
If you find that the printer is going into Power Saver mode too often and you do not want to
wait while the printer warms up, increase the length of time before the printer goes into Power
Saver mode. Change the timeout value as follows:
1. On the control panel, select
Printer Setup, and then press the OK button.
2. Select
Printer Controls, and then press the OK button.
3. Select
Power Saver, and then press the OK button.
4. Press the Down Arrow or Up Arrow button to scroll to a selected Power Saver timeout
value. Select a larger value if you want to extend the length of time before the printer goes
into Power Saver mode.
5. Press the OK button.

Dell 7330 Specifications

General

Brand	Dell
Model	7330
Category	All in One Printer
Language	English