4. Disconnect the power and data cables from the back of the floppy drive.
5. Replace the computer cover. See Replacing the Computer Cover.
6. Connect your computer and devices to electrical outlets, and turn them on.
Installing a Floppy Drive
1. Follow the procedures in Before You Begin.
2. Remove the floppy drive and bracket from its packaging.
3. If you are installing a new drive:
a. Remove the drive-panel insert that blocks the FlexBay.
b. Remove the four shoulder screws from the drive-panel insert.
4. If you are replacing an existing drive:
a. Remove the existing drive.
b. Remove the four shoulder screws from the existing drive.
5. Insert the four shoulder screws into the sides of the new floppy drive and tighten them.
6. Attach the power and data cables to the floppy drive.
7. Locate the correct guidance-slot for the drive (slot 2) and align the shoulder screws with the screw guides.
NOTICE: To connect a network cable, first plug the cable into the network port or device, and then plug it into the computer.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
To Next Page
Loading...
Need help?
General