5. Install the coin-cell battery.
6. Install the battery.
7. Install the solid-state drive in M.2 slot two.
8. Install the solid-state drive in M.2 slot one.
9. Install the WLAN card.
10. Install the memory module.
11. Install the base cover.
12. Follow the procedure in After working inside your computer.
Power button with fingerprint reader
Removing the power button with fingerprint reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the memory module.
4. Remove the WLAN card.
5. Remove the solid-state drive in M.2 slot one.
6. Remove the solid-state drive in M.2 slot two.
7. Remove the battery.
8. Remove the coin-cell battery.
9. Remove the left fan.
10. Remove the right fan.
11. Remove the heat sink.
12. Remove the power-adapter port.
13. Remove the system board.
NOTE: The system board can be removed along with the heat sink.
Steps
1. Locate the power button with fingerprint reader on your computer.
52
Removing and installing components
To Next Page
Loading...
Need help?
General
