Steps
1. Connect the media-card reader cable to the system board and close the latch to secure the cable.
2. Insert the media-card reader into the media-card reader slot.
3. Align the screws on the media-card reader with the screw holes on the slot on the display assembly base.
4. Replace the screw (M2x3) that secure the media-card reader to the display-assembly base.
Next steps
1. Install the system-board shield.
2. Install the stand.
3. Install the bottom cover.
4. Install the back cover.
5. Follow the procedure in After working inside your computer.
Speakers
Removing the speakers
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the back cover.
3. Remove the bottom cover.
4. Remove the stand.
5. Remove the system-board shield.
About this task
The following image indicates the location of the speakers and provides a visual representation of the removal procedure.
Removing and installing components
33
To Next Page
Loading...
Need help?
General