Steps
1. Using the alignment posts, place the speakers on the palm-rest and keyboard assembly.
NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3. Connect the speaker cable to the system board.
Next steps
1. Install the M.2 2230 solid-state drive, if applicable.
2. Install the M.2 2280 solid-state drive, if applicable.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
Heat sink (integrated graphics)
Removing the heat sink (integrated graphics)
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
NOTE: For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin
can reduce the heat transfer capability of the thermal grease.
The following image indicates the location of the heat sink and provides a visual representation of the removal procedure.
NOTE: This heatsink is installed on the system that supports the 10
th
Generation Intel Core i3 processor.
Removing and installing components 35
To Next Page
Loading...
Need help?
General