Steps
1. Lift the system board shield off the system board.
2. Disconnect the rear-facing camera FPC from the connector on the system board.
3. Remove the two (M1.6x3) screws that secure the rear-facing camera in place.
4. Lift the rear-facing camera out of the system.
Installing the rear-facing camera
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the rear-facing camera module and provides a visual representation of the
installation procedure.
30
Removing and installing components
To Next Page
Loading...
Need help?
General