4. To remove the speaker module:
a. Remove the M2.0x3.0 screws (4) that secure the speaker module to the computer [1].
b. Lift the speaker module from the computer .
NOTE: Ensure to un-route the speaker cable from the routing clips.
Installing speaker module
1. Place the speaker module into the slots on the computer.
2. Route the speaker cable through the retention clips on the computer.
3. Connect the speaker cable to the connector on the system board.
4. Install the:
a. battery
b. base cover
5. Follow the procedure in After working inside your computer.
Coin-cell battery
Removing the coin cell battery
1. Follow the procedure in Before working inside your computer.
2. Remove the :
a. base cover
3. Disconnect the battery
4. To remove the coin cell battery:
a. Disconnect the coin cell battery cable from the connector on the system board [1].
18
Disassembly and reassembly