3. Remove the power-adapter port cable from the routing guide on the palm-rest and keyboard assembly.
4. Remove the screw (M2x3) that secures the power-adapter port to the palm-rest and keyboard assembly.
5. Lift the power-adapter port along with its cable, off the palm-rest and keyboard assembly.
Installing the power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power-adapter port and provides a visual representation of the installation
procedure.
Steps
1. Place the power-adapter port into the slot on the palm-rest and keyboard assembly.
2. Replace the screw (M2x3) that secures the power-adapter port to the palm-rest and keyboard assembly.
3. Route the power-adapter port cable through the routing guide on the palm-rest and keyboard assembly.
4. Adhere the tape that secures the power-adapter port cable to the system board.
5. Connect the power-adapter port cable to the system board.
6. Close the right display-hinge.
Next steps
1. Install the display assembly.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
4. Exit Service Mode.
42
Removing and installing components
To Next Page
Loading...
Need help?
General
