Power button
Removing the power button
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter Service Mode.
3. Remove the base cover.
4. Remove the fan.
5. Remove the display assembly.
6. Remove the I/O board.
About this task
The following image indicates the location of the power button and provides a visual representation of the removal procedure.
Steps
1. Remove the two screws (M1.6x2) that secure the power button to the palm-rest and keyboard assembly.
2. Lift the power button off the slot on the palm-rest and keyboard assembly.
Installing the power button
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power button and provides a visual representation of the installation
procedure.
Removing and installing components
49
To Next Page
Loading...
Need help?
General
