Dell PowerEdge 1950 User Manual

92 Installing System Components
3 Slide the system-board tray toward the back of the chassis until it locks into position.
4 If applicable, replace the RAC card. See "RAC Card" on page 71.
5 If applicable, replace the TOE key. See "Activating the Integrated NIC TOE" on page 67.
6 Replace the heatsink(s) and microprocessor(s).
7 Replace the memory modules. See "Installing Memory Modules" on page 65.
8 Replace both the center and left risers. See "Installing an Expansion-Card Riser" on page 83.
9 Replace any expansion card(s). See "Installing an Expansion Card" on page 61.
10 Replace the sideplane board. See "Installing the Sideplane Board" on page 86.
11 Replace the fan modules. See "Replacing a Cooling Fan Module" on page 49.
12 Replace the memory cooling shroud. See "Replacing the Memory Cooling Shroud" on page 53.
13 Replace the power supplies. See "Replacing a Power Supply" on page 55.
14 Connect any cables to the system.
15 Close the system. See "Opening and Closing the System" on page 46.
16 Replace the bezel. See "Removing and Replacing the Front Bezel" on page 45.

Dell PowerEdge 1950 Specifications

General

Processor Sockets	2
Chipset	Intel 5000X
Memory Slots	8 DIMM slots
Network	Dual embedded Broadcom NetXtreme II 5708 Gigabit Ethernet
Form Factor	1U Rack
Processor	Intel Xeon 5100, 5300 series
Memory	Up to 32GB DDR2
Storage	SAS or SATA
Drive Bays	Two 3.5" SAS or SATA drives or Four 2.5" SAS or SATA drives
RAID Controller	PERC 5/i, PERC 6/i
Power Supply	670W redundant power supply (optional)
Operating System Support	Microsoft Windows Server, Red Hat Linux, SUSE Linux