Dell PowerEdge R210 User Manual

Installing System Components 83
The system should have already changed the value to reflect the newly
installed memory.
13 If the value is incorrect, one or more of the memory modules may not be
installed properly. Repeat step 2 through step 12 of this procedure, checking to
ensure that the memory modules are firmly seated in their sockets.
14 Run the system memory test in the system diagnostics. See "Running the
Embedded System Diagnostics" on page 126.
Removing Memory Modules
WARNING: The memory modules are hot to touch for some time after the system has
been powered down. Allow time for the memory modules to cool before handling
them. Handle the memory modules by the card edges and avoid touching the
components on the memory module.
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your product
documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty.
Read and follow the safety instructions that came with the product.
CAUTION: To ensure proper system cooling, memory-module blanks must be installed
in any memory socket that is not occupied. Remove memory-module blanks only if you
intend to install memory in those sockets.
1 Turn off the system, including any attached peripherals, and disconnect the
system from the electrical outlet.
2 Open the system. See "Opening the System" on page 62.
3 Remove the cooling shroud. See "Removing the Cooling Shroud" on page 77.
4 Locate the memory module sockets. See Figure 6-1 .
5 Press down and out on the ejectors on each end of the socket until the memory
module pops out of the socket. See Figure 3-11.
Handle each memory module only on either card edge, making sure not to
touch the middle of the memory module.
6 Replace the cooling shroud. See "Installing the Cooling Shroud" on page 79.
7 Close the system. See "Closing the System" on page 63.
8 Reconnect the system and peripherals to their power sources, and turn them
on.
book.book Page 83 Wednesday, August 12, 2009 4:51 PM

Dell PowerEdge R210 Specifications

General

Tcase	72.6 °C
Bus type	DMI
Stepping	C2
FSB Parity	No
Processor cache	4 MB
Processor cores	2
Processor model	i3-530
System bus rate	2.5 GT/s
Processor family	Intel® Core™ i3
Processor series	Intel Core i3-500 Desktop Series
Processor socket	LGA 1156 (Socket H)
Processor threads	4
Processor codename	Clarkdale
Execute Disable Bit	Yes
Motherboard chipset	Intel® 3420
Processing Die size	81 mm²
Processor frequency	2.93 GHz
Processor cache type	Smart Cache
Processor lithography	32 nm
Processor manufacturer	Intel
Processor package size	37.5 x 37.5 mm
Processor front side bus	- MHz
Processor operating modes	64-bit
Graphics & IMC lithography	45 nm
PCI Express configurations	1x16, 2x8
Supported instruction sets	SSE4.2
Thermal Design Power (TDP)	73 W
Number of processors installed	1
CPU multiplier (bus/core ratio)	22
Physical Address Extension (PAE)	36 bit
Maximum number of PCI Express lanes	16
Memory types supported by processor	DDR3 1066/1333
Number of Processing Die Transistors	382 M
Memory channels supported by processor	Dual
Memory bandwidth supported by processor (max)	21 GB/s
Maximum internal memory supported by processor	16 GB
HDD size	3.5 \
RAID support	-
Optical drive type	DVD-RW
Total storage capacity	250 GB
Maximum storage capacity	2 TB
Memory slots	4x DIMM
Internal memory	2 GB
Memory clock speed	1333 MHz
Buffered memory type	Unregistered (unbuffered)
Internal memory type	DDR3-SDRAM
Memory layout (slots x size)	2 x 1 GB
Maximum graphics card memory	8 MB
On-board graphics card model	Intel® HD Graphics
On-board graphics card base frequency	733 MHz
I/O ports	1x PCIe x16 G2
Graphics card	G200eW
Dimensions (WxDxH)	431 x 393.7 x 42.6 mm
Non-operating relative humidity (non-condensing)	5 - 95 %
Networking features	Gigabit Ethernet
PS/2 ports quantity	0
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
PCI Express slots version	2.0
Power supply	250 W
Power requirements	100 - 240 V
Compatible operating systems	Windows SQL Server 2008 R2/Small Business Server 2008/Essential Business Server 2008/Foundation R2/Server 2008 SP2/Server 2008 R2, Novell, Linux.
Chassis type	Rack (1U)
Storage temperature (T-T)	-40 - 65 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Processor ARK ID	46472

Weight and Dimensions

Depth	393.7 mm
Width	431 mm
Height	42.6 mm