Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Insert the memory module into the memory-module connector until the memory module snaps into position and the securing clip locks
in place.
CAUTION:
To prevent damage to the memory module, hold the memory module by the edges. Do not touch the
components on the memory module.
NOTE: The securing clips return to the locked position. If you do not hear the click, remove the memory module and
reinstall it.
NOTE: If the memory module is difficult to remove, gently ease the memory module back and forth to remove it from
the slot.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Wireless card
Removing the wireless card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the 3.5-inch hard drive.
About this task
The following images indicate the location of the wireless card and provide a visual representation of the removal procedure.
30
Removing and installing components
To Next Page
Loading...
Need help?
General
