10
ANTI-TILT BRACKET
Important!
To restrain the appliance and
prevent it tipping accidentally,
fit a bracket to its rear to fix it
securely to the wall. Make sure
you also fit the supplied lock
pin to the anti-tilt bracket.
To fit the anti-tilt bracket:
1. After you have located where
the cooker is to be positioned,
mark on the wall the place
where the two screws of the
anti-tilt bracket have to be fitted.
Please follow the indications
given in Fig. 8a.
2. Drill two 8 mm diameter holes
in the wall and insert the plastic
plugs supplied.
Important!
Before drilling the holes,
check that you will not dam-
age any pipes or electrical
wires.
3. Loosely attach the anti-tilt brack-
et with the two screws supplied.
4. Move the cooker to the wall and
adjust the height of the anti-tilt
bracket so that it can engage in
the slot on the cooker’s back, as
shown in Fig. 8a.
5. Tighten the screws attaching the
anti-tilt bracket.
6. Push the cooker against the wall
so that the anti-tilt bracket is fully
inserted in the slot on the cook-
er’s back.
7. Access the bracket and fit the
lock pin:
• Open the pivoting panel (Fig.
8b).
• Fit the lock pin through the
bracket, as shown (Fig. 8c).
• Close the pivoting panel.
To Next Page
Loading...
Need help?
General
