37
OVEN TRAY
The oven tray must be correctly
placed on its wire shelf support (fig.
40) then inserted into the side run-
ners (fig. 41).
OVEN FLOOR
The oven floor “F” (fig. 41) can be
easily removed to facilitate clean-
ing.
Remember to replace the floor cor-
rectly afterwards.
Be careful not to confuse the tray
“L” with the oven floor “F”.
Figure 41
Figure 40
GRILL HEATING ELEMENT
The heating element is self-cleaning and does not require maintenance.
L
F
REPLACING THE OVEN LIGHT BULB
Switch the cooker off at the mains.
When the oven is cool, unscrew and replace the bulb with another one resistant to
high temperatures (300°C), voltage 230-240 V~ (50 Hz), E14
and same power (check
watt power as stamped in the bulb itself) of the replaced bulb.
Note: Oven bulb replacement is not covered by your guarantee.
To Next Page
Loading...
