11
Fig. 20
C
C
ADJUSTING FENCE 90 DEGREES TO BLADE
If the fence (A) Fig. 19 is removed from the saw, re-adjust it so that it is 90 degrees to the blade when the fence is
replaced.
1. Place one end of the square (B) Fig. 19 against the fence (A) and the other end against the blade.
2. If an adjustment is necessary, loosen the two screws (C) Fig. 20, and adjust fence 90 degrees to the blade.
3. Tighten the two screws (C).
Fig. 21
A
B
ADJUSTING DOWNWARD TRAVEL
OF SAW BLADE
1. The downward travel of the saw blade should be
limited to prevent the saw blade from contacting
any metal surfaces of the machine. This adjustment
is made by loosening lock nut (A) Fig. 21 and
turning the adjusting screw (B) in or out.
2. Lower the blade as far as possible. Rotate the blade
by hand to make certain the teeth do not contact
any metal surfaces and adjust if necessary.
3. Tighten lock nut (A).
Fig. 19
A
B
If the size of the workpiece causes your
hand to be within the hazard zone of of
the saw blade, clamp the workpiece in
place before making cut.
1. Before cutting, make certain the cutting arm and
table are at their correct settings and firmly locked in
place.
2. Place the workpiece on the table and hold or clamp
it firmly against the fence. Fig. 22 illustrates an
accessory work clamp (A). The clamp (A) can also
be used on the right side of the machine.
3. For best results, cut at a slow, even cutting rate.
4. Never attempt freehand cutting (wood that is not
held firmly against the fence and table).
Fig. 22
A
TYPICAL OPERATIONS AND HELPFUL HINTS
Disconnect machine from power source.
Disconnect machine from power source.
To Next Page
Loading...
Need help?
General