EN
8
Set parallax to the 100 meters position. Set magnification to the
highest power. From a steady rest position, fire three rounds at a
target 100 meters away. Observe point of impact on the target and
correct aim.
Caution: first adjust mount to the scope!
Make major correction by adjusting mount to set up the point of
impact about 15 cm from aim (adjust mount to riflescope). Then you
can start to use windage and elevation screws.
The reticle adjustment turrets are set to the middle “0” position.
When zeroing, we recommend adjusting the turrets vertically or
horizontally from the „0” setting by about one turn. Attempts at
much greater adjustments can
cause spring blockage, reticle
displacement and a parallax error.
The turrets can have a locking
mechanism to prevent them
being knocked out of position
accidentally. To unlock the turret,
pull it up, and to lock again after
completing your adjustment,
press it down to lock it (Fig. 3).
CAUTION!
Avoid over-tightening the rings. This can damage the scope,
aecting performance or rendering it inoperable. There should
be a slight even gap on the left and right sides of both sets of
rings, between the top and bottom halves. We recommend
tightening the bolts with a torque wrench with a force not
exceeding 1.7-1.8 Nm.
CAUTION!
All discharging of firearms shuold be done at an approved range or
equally safe area. Use of eye and ear protection is recommended.
Zeroing
Fig. 3
To Next Page
Loading...
Need help?
General