Only qualified persons are allowed to install, wire and maintain hybrid servo
drives.
When the hybrid servo drive uses an external terminal as its source of operation
commands, the motor may start running immediately after the power is supplied.
In this case, it may be dangerous to any on-site personnel.
The oil tank adjusts the oil volume, and the oil volume must be enough for the
hybrid servo drive to orun. It is absolutely prohibited to run the oil pump without
oil.
The oil temperature of the oil tank must be in control within the required range,
and if necessary, install a cooler.
Release completely the air inside the system before you add more pressure to
the system.
Do a no-load running of the oil pump under the jog mode to ensure sufficient
lubrication of the oil pump.
DO NOT install the hybrid servo drive in a place subjected to high temperature,
direct sunlight, high humidity, excessive vibration, corrosive gases or liquids, or
airborne dust or metallic particles.
Only use hybrid servo drives within specification. Failure to comply may result in
fire, explosion or electric shock.
When the motor cable between hybrid servo drive and motor is too long, the
layer insulation of the motor may be damaged. Please add an AC output reactor
to prevent damage to the motor. Refer to Appendix A-4 Reactor for details.
The rated voltage for hybrid servo drive must be 240V ( 480V for 460V
models) and the mains supply current capacity must be 5000A RMS (10000A
RMS for the 40hp (30kW) models).
Pay attention to the following when transporting and installing this package
(including wooden crate, wood stave and carton box):
1. If you need to sterilize, deworm the wooden crate or carton box, do not
use steamed smoke sterilization or you will damage the product inside.
2. Use other ways to sterilize or deworm.
3. You may use high temperatures to sterilize or deworm. Leave the packaging
materials in an environment of over 56°C for 30 minutes.
4. It is strictly forbidden to use steamed smoking sterilization. The warranty does
not cover the product damaged by steamed smoking sterilization
NOTE
For a detailed explanation of the product specifications, the cover or the safety shields will be
disassembled on some pictures or graphics. When the product is put to operation, please
install the top cover and safety shield and ensure correct wiring. Refer to the manual to ensure
safe operation.
The figures in this manual are for reference only, they may be slightly different from your actual
drive, but it will not affect your customer rights.
The content of this manual may be revised without prior notice. Please consult our distributors
or download the latest version at
http://www.deltaww.com/iadownload_acmotordrive
To Next Page
Loading...
Need help?
General
