Denon AVC-A1HD User Manual


Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting
Resetting the Microprocessor
Perform this procedure if the display is abnormal or if operations
cannot be performed.
All settings are reset when the microcomputer is reset.
1
Turn off the power using <POWER>.
2
Press <POWER> while simultaneously pressing
<STANDARD> and <HOME THX CINEMA>.
3
Once the display starts ashing at intervals of about 1
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
Last Function Memory
This stores the settings as they were directly before the standby
mode was set.
When the power is turned back on, the settings are restored to as
they were directly before the standby mode was set.
Backup Memory
The various settings are backed up for about 1 week, even if the
power is turned off or the power cord is disconnected.
<POWER>
<STANDARD>
<HOME THX CINEMA>
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
Playback

Denon AVC-A1HD Specifications

General

Type	AV Amplifier
Channels	10.2
HDMI Inputs	6
HDMI Outputs	2
Multi-Room Capability	Yes
Audyssey	Audyssey MultEQ XT
Total Harmonic Distortion	0.05%
Frequency Response	10 Hz - 100 kHz (+1, -3 dB)
Signal-to-Noise Ratio	110 dB
Input Sensitivity	200 mV
Input Impedance	47 k ohms
HDMI Version	1.3a
Audio Formats Supported	Dolby TrueHD, DTS-HD Master Audio
THX Certified	Yes (THX Ultra2 Plus)
DTS	DTS Neo:6
Video Upscaling	Yes (up to 1080p)
Video Inputs	Component x 3
Video Outputs	1 x Component, 1 x Composite
Power Output	150W per channel (8 ohms, 20Hz-20kHz, 0.05% THD)