Getting Started Connections Setup Playback Remote Control Information Troubleshooting
ENGLISH
SpecificationsConnections
"6%*0
"6%*0
3-
065065
$0"9*"-
R
L
R
L
CD Player
Select the terminal to use and connect the device.
CD player
When using an optical cable for the digital audio connection, make
the settings at “System Setup” – “Input Setup” – “Digital In
Assign” (vpage 24).
iPod
®
iPod
• With the default settings, the iPod can be used connected to the
VCR (iPod) connector.
• To assign the iPod to a connector other than VCR (iPod), make
the settings at “System Setup” – “Input Setup” – “iPod Assign”
(vpage 24).
Use a DENON control dock for iPod (ASD-1R, ASD-11R, ASD-3N
or ASD-3W, sold separately) to connect the iPod to the AVR-589.
For instructions on the control dock for iPod settings, refer to the
control dock for iPod’s operating instructions.
47*%&0
065
"6%*0 7*%&0
$0.10/&/57*%&0
: 1# 13
7*%&0
065065
"6%*0
3-
065 065
)%.*
015*$"-
065
R
L
R
L
TV/CABLE Tuner
Select the terminal to use and connect the device.
TV tuner
When using a coaxial cable for the digital audio connection, make the settings
at “System Setup” – “Input Setup” – “Digital In Assign” (vpage 24).
NOTE
The audio signal input to the HDMI input connector cannot be
played on the AVR-589. Input the audio signal to the digital audio input
connector or analog audio input connector.
NOTE
Because video signals are output from the AVR-589’s monitor output terminal
in the same format as the video input signals, the monitor output terminal
should be of the same type as the terminal used for input.
NOTE
To playback iPod Video or Photos on a TV monitor, connect
the TV to the S-Video Out terminal of AVR-589.
To Next Page
Loading...
Need help?
General
