Quick Select Function
With this function, the currently playing input source, volume
level, surround mode, MultEQ, Dynamic Volume, DV setting and
front speaker can be stored in the memory.
1
Set the input source, input mode, surround mode,
MultEQ settings and volume to the conditions you
want to store.
2
Press and hold QUICK SELECT until “Memory”
appears on the display.
The current settings will be memorized.
To call out the settings, press QUICK SELECT at which the desired
settings were stored.
Input Source Volume
Quick Select 1 DVD/HDP –40 dB
Quick Select 2 TV/CBL –40 dB
Quick Select 3 VCR –40 dB
[Quick Select Defaults]
Personal Memory Plus Function
This function sets the settings (input mode, surround mode,
MultEQ, Dynamic EQ, Dynamic Volume, audio delay etc.) last
selected for the individual input sources.
When you switch to an input source, the settings are automatically
set to the ones that were set the last time that input source was
used.
The surround parameters, tone control, MultEQ settings and the
volumes of the different speakers are stored for the individual surround
modes.
Last Function Memory
This stores the settings as they were directly before the standby
mode was set.
When the power is turned back on, the settings are restored to as
they were directly before the standby mode was set.
Backup Memory
The various settings are backed up for about 1 week, even if the
power is turned off or the power cord is disconnected.
Resetting the Microprocessor
Perform this procedure if the display is abnormal or if operations
cannot be performed.
When the microprocessor is reset, all the settings are reset to
their default values.
1
Turn off the power using <POWER>.
2
Press <POWER> while simultaneously pressing
<INPUT MODE> and <SPEAKERS A>.
3
Once the display starts ashing at intervals of about 1
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
Getting Started Connections Setup Playback Remote Control Troubleshooting
ENGLISH
Specifications
Button located on both the main unit and the remote control
unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
<INPUTMODE>
QUICK SELECT
<POWER>
<SPEAKERS A>
[Front]
Information
To Next Page
Loading...
Need help?
General
