o
Power does not turn on / Power is turned off
Symptom Cause / Solution Page
Power does not turn on.
0
Check whether the power plug is correctly inserted into the power outlet. 52
Power automatically turns
off.
0
The sleep timer is set. Turn on the power again. 119
0
“Auto Standby” is set. “Auto Standby” is triggered when there is no operation for a set amount of time. To
disable “Auto Standby”, set “Auto Standby” on the menu to “Off”.
189
Power turns off and the
power indicator flashes in
red approx. every 2
seconds.
0
The protection circuit has been activated due to a rise in temperature within this unit. Turn the power off,
wait about an hour until this unit cools down sufficiently, and then turn the power on again.
244
0
Please re-install this unit in a place having good ventilation. －
Power turns off and the
power indicator flashes in
red approx. every 0.5
seconds.
0
Check the speaker connections. The protection circuit may have been activated because speaker cable
core wires came in contact with each other or a core wire was disconnected from the connector and
came in contact with the rear panel of this unit. After unplugging the power cord, take corrective action
such as firmly re-twisting the core wire or taking care of the connector, and then reconnect the wire.
28
0
Turn down the volume and turn on the power again.
54
0
This unit’s amplifier circuit has failed. Unplug the power cord and contact our customer service center. －
Power does not turn off
even when the power
button is pressed, and the
display shows “ZONE2
On”.
0
The power supply of ZONE2 is turned to ON. To turn off the power supply of this unit (standby), press the
ZONE2 ON/OFF on the main unit, or press the POWER X
button after pressing the ZONE2 button on the
remote control unit to turn off the power supply of ZONE2.
－
Contents Connections Playback Settings Tips Appendix
203
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
Weight and Dimensions
