Denon AVR-X3000 User Manual

187
Appendix
SettingsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Tips
2 Desired sound does not come out
Symptom Cause/Solution Page
The volume does not increase. •The maximum volume is set too low. Set the maximum volume using “Limit”on the menu.
•Appropriate volume correction processing is performed according to the input audio format
and settings, so the volume may not reach the upper limit.
138,173
–
No sound comes out with the HDMI
connection.
•Check the connection of the HDMI connectors.
•When outputting HDMI audio from the speakers, set “HDMI Audio Out” on the menu to
“AVR”. To output from the TV, set “TV”.
•When using the HDMI control function, check that the audio output is set to the AV amplifier
on the TV.
31,32
144
113
No sound comes out of a specific
speaker.
•Check that the speaker cable is properly connected.
•Check that a selection other than “None” is set for the “Speaker Config.” setting in menu.
•Check the “Assign Mode” setting in the menu.
•When the sound mode is “STEREO” and “VIRTUAL”, audio is only output from the front
speakers and subwoofer.
24
163,164
162
–
No sound is produced from
subwoofer.
•Check the subwoofer connections.
•Turn on the subwoofer’s power.
•Set “Speaker Config.” – “Subwoofer” on the menu to “Yes”.
•When “Speaker Config.” – “Front” in the menu is set to “Large”, depending on the input
signal and the sound mode, no sound may be output from the subwoofer.
•When no subwoofer audio signal (LFE) is included in the input signals, no sound may be
output from the subwoofer.
•You can make the subwoofer always output sound by setting the subwoofer mode to
“LFE+Main”.
25
–
163
163
167
167

Denon AVR-X3000 Specifications

General

Receiver type	Surround
Frequency range	10 - 100000 Hz
Output impedance	16 Ω
Input sensitivity	200 mV
Pre-out connectivity	Yes
Audio output channels	7.1 channels
Signal-to-Noise Ratio (SNR)	102 dB
Total Harmonic Distortion (THD)	0.08 %
Power output per channel (1KHz@6 Ohm)	135 W
Power output per channel (20-20KHz@8 Ohm)	105 W
HDMI in	7
Audio (L/R) in	5
Composite video in	3
Ethernet LAN (RJ-45) ports	1
Component video (YPbPr/YCbCr) in	2
Connectivity technology	Wired
Speakers connectivity type	Banana connector
Audio formats supported	AAC, FLAC, MP3, WAV, WMA
Image formats supported	JPG
Wi-Fi	No
RDS features	PTY, TP
AM band range	520 - 1710 kHz
FM band range	87.5 - 108 MHz
Supported radio bands	AM, FM
Internet radio services supported	Spotify, vTuner
Supported video modes	1080i, 1080p, 480p, 576p, 720p
Display	VFL
Color depth	24 bit
Aspect ratio	4:3, 16:9
Product color	Black
Audio decoders	DTS Neo:X, Dolby Digital, Dolby Digital EX, Dolby Digital Plus, Dolby Pro Logic II, Dolby Pro Logic IIx, Dolby Pro Logic IIz, Dolby TrueHD, DTS, DTS-ES (Discrete 6.1), DTS-ES (Matrix 6.1), DTS-HD, DTS-HD Master Audio
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Apple docking compatibility	iPhone, iPod
AC input voltage	230 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.1 W
Power consumption (typical)	600 W
Cables included	AC

Weight and Dimensions

Depth	379 mm
Width	434 mm
Height	167 mm
Weight	10700 g