Denon DAP-2500A User Manual

ae
EEE
3/6225
OO
A
<.) Playing a Digital Program Source
1. Set the DIGITAL DIRECT switch @ to the “ON” position. Indicator @ will light.
2. Select the desired program source with the INPUT SELECTOR (digital input switching) and the DAT MONITOR.
) | PROGRAM SOURCE INPUT SELECTOR DAT MONITOR
| Digital source with optical output DIGITAL-1 OFF
Digital source with a coaxial type digital output DIGITAL-2, 3 OFF
Coaxial type digital source from DAT - ON
The sampling frequency indicator will light up in correspondence with the sampling frequency of the digital signal that has
been
input.
i
3.
Begin
playing
the
program
source.
For information on the operating method, refer to the operating instructions for the various components.
4. Adjust the volume. :
(© Analog Recording to the Tape Deck and Tape Copying.
1. Select the program source that you wish to record with the MONITOR/COPY (recording output switching).
PROGRAM SOURCE MONITOR/COPY
When recording program sources connected to PHONO ~ AUX/VIDEO-2 P SOURCE
; When recording from the component connected to the TAPE-1 terminals to TAPE-2 | TAPE-1 / 1>2 .
1 When recording from the component connected to the TAPE-2 terminals to TAPE-1 TAPE-2 / 21
ia When recording a program source connected to DIGITAL-1, 2, 3 DAT MONITOR DAC OUT
(Set the DIGITAL DIRECT switch to “ON” at this time) |
Don't change the MONITOR/COPY switch while recording, or you will get intermittent sounds.
2. Begin playing the program source.
3. Begin recording with the tape deck.
For information on the operating method, refer to the operating instructions for the various components.
') Digital Copying to the Digital Tape Deck
NOTE: In some cases digital copying is not possible due to differences in sampling frequency, etc.
For digital tape decks equipped with digital recording input terminals, copying of the unchanged digital signal from the DAT
OUT
terminals
is
possible.
j
1. Set the DIGITAL DIRECT switch @ to “ON”.
2. Select the program source that you wish to record with the DIGITAL INPUT SELECTOR (DIGITAL-1, 2, 3).
3. Begin playing the digital program source.
) 4. Begin recording with the digital tape deck.
For
information
on
the
operating
method,
refer
to
the
operating
instructions
for
the
various
components.
© Monitoring the Recording
A
recording
in
progress
can
be
monitored
if
a
tape
deck
with
three
individual
heads
for
recording
and
playback
is
used.
A
tape
deck
in
which
a
common
head
is
used
for
both
recording
and
playback
cannot
be
used
to
monitor
recording.
Set
the
MONITOR/COPY
knob
of
TAPE-1
or
TAPE-2
to
corresponding
to
the
tape
deck
that
is
being
used
for
the
recordin
g.
Use
the MONITOR/COPY switch to switch between the recording monitor and the program source.
NOTE: When digital signals are being input from a CD player, DAT, etc., noise may be produced from the DAP-2500A if the
power of the component sending digital signals is turned off before the power of the DAP-2500A. We recommend
either
turning
off
the
power
of
the
DAP-2500A
first,
or
turning
down
the
DAP-2500A’s
main
volume
control
before
turning off the power of the CD player, DAT, etc.
13

Denon DAP-2500A Specifications

General

Brand	Denon
Model	DAP-2500A
Category	Amplifier
Language	English