RC-41 REMOTE CONTROL UNIT
This is the separately sold wristwatch type remote control unit.
TIMER-CONTROLLED PLAYBAC
INSTALLATION PRECAUTIONS
The CD player uses a microcomputer for controlling internal
electronic circuits. In the event that the player is used while a
near-by tuner or TV is turned on, although unlikely, interference
could occur either in the sound from the tuner or the picture of the
TV. To avoid this, please take the following precautions.
0 Keep the CD player as far away from the tuner or TV set as
possible.
Keep the power cable and connecting cable of the CD player
separate from the antenna wires of the tuner and TV.
Interference is particular likely to occur when an indoor antenna
or a 300 0 /ohm feeder cable is used. Thus, use of an outdoor
antenna and 75 f2/ohm coaxial cable is strongly recommended.
Both CD: DN-600F, and deck d1, d2: DRW-585P can be
operated by switching the display between CD, d1, d2 with
select switch.
*Hand held RC-U620 remote is also available.
Operation
1. Turn on the power of all system components.
2. Set the input selector on the amplifier to correspond to the
inputs the CD player is connected to.
3. Make sure a disc has been loaded in the disc holder.
4. Check the time on the timer and then set the desired
turn-on time.
5. Turn the audio timer ON.
Power is turned off automatically in all components
connected to the timer.
When the preset turn-on time is reached, power is turned on
in the system components, and CD playback starts from the
first track.
6.
300 I? /ohm feeder cable 75 i2/ohm coaxial cable
13
To Next Page
Loading...
Need help?
Audio Functions and Display
